Die Suche ergab 773 Treffer
- 03.02.2011, 18:54
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
...now you have eliminated one source that could have caused the problem. It is time to check the transisitors and the diodes, either by comparing the voltages from the left and right channel or desolder them and check them individual. Because you have only a Multimeter for testing here are two link...
- 03.02.2011, 13:50
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
- 02.02.2011, 18:15
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
....maybe the easier way for you to check the pre-amp is switching the red and yellow wires (left/right) and see whether you get the same signal strength on the good channel of the power amp. If you get the same volume your pre-amp seems to be okay. Make sure that the controls on the front panel are...
- 02.02.2011, 16:57
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
You can check the resistors the same way. Because of the low resistance of .22 Ohms you probably don't get the exact reading with your Multimeter, but a comparision of the four readings should give you a good idea. 084/085 is correct. When you measured the voltages did you disconnect the pre-amp fro...
- 02.02.2011, 16:03
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
I mean only the electrolytic caps. Yes, bad caps or defective transistors can be the cause. Before you replace C609/709 have them tested, they are pretty expensive. Can you test the output of the pre-amp, oscilloscope would be best? Wilhelm If you can, check also the four big emitter-resistors R619/...
- 01.02.2011, 23:53
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
It seems to me that the capacitors C603,C703 are currently connected to R625,725 which is not according to the schematics. Remove and solder them into the pcb according to the original layout (the correct place is clearly marked). Regards Wilhelm Have a look whether you can find the fuses (Si601,701...
- 01.02.2011, 15:31
- Forum: Tonbandgeräte
- Thema: TG1000 Voltage Settings
- Antworten: 5
- Zugriffe: 5938
- 31.01.2011, 00:21
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
- 30.01.2011, 17:54
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
Hi, for the power amp to work properly (without these capacitors) the entire circuit, including the power supply, would have to be changed. The voltage for the power amp is 65VDC, this means, without C609,C709 half of the DC voltage would go to the speakers. This would destroy them and totally overl...
- 29.01.2011, 22:07
- Forum: Plattenspieler
- Thema: Effektive Tonarmmasse Braun PCS 5
- Antworten: 20
- Zugriffe: 21029
Hallo Raimund. ich stimme Deinen Ausfuehrungen bezueglich der Shure-Systeme uneingeschraenkt zu. In meinem PS1000 benutze ich zur Zeit ein M97xE und bin vollauf zufrieden. Beruecksichtigt man Preis und Leistung gibt es wohl derzeit nichts besseres. Ich werde es demnaechst einmal in den PCS5 einsetze...
- 29.01.2011, 19:12
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
Hi Juergen, Somebody must have modified your power amp. According to your pictures, there are no fuses on the board and no capacitors in the output stage. Somebody must have mounted the capacitors C609, C709 in a different spot otherwise this kind of amp would blow your speakers in a second (high DC...
- 26.01.2011, 08:31
- Forum: Kompaktanlagen
- Thema: Dem TC-20 wieder zu altem glanz verhelfen...
- Antworten: 12
- Zugriffe: 13059
- 26.01.2011, 07:55
- Forum: Kompaktanlagen
- Thema: Dem TC-20 wieder zu altem glanz verhelfen...
- Antworten: 12
- Zugriffe: 13059
Stuetzpunkt 1 = rechter Kanal R, rotes Kabel Stuetzpunkt 2 = Masse 0, neutral Stuetzpunkt 3 = linker Kanal L, gelbes Kabel Beim linken Kanal hatte ich mich verschrieben, sorry. Im Prinzip kannst Du jeden Stuetzpunkt so belegen wie Du es willst. rotes Kabel = rechter Kanal, gelbes Kabel = linker Kana...
- 26.01.2011, 00:58
- Forum: Kompaktanlagen
- Thema: Dem TC-20 wieder zu altem glanz verhelfen...
- Antworten: 12
- Zugriffe: 13059
Die originale Anschlussconfiguration ist wie folgt: Stuetzpunkt 1 = rechter Kanal R, rotes Kabel Stuetzpunkt 2 = Masse 0, neutral Stuetzpunkt 2 = linker Kanal L, gelbes Kabel von diesem Stuetzpunkten erfolgt auch der Anschluss des NF-Kabels zum Verstaerker (Umschalter). Der Masseanschluss (Stuetzpun...
- 23.01.2011, 23:14
- Forum: Regie-Reihe
- Thema: Rätselhafter Fehler Regie 510
- Antworten: 14
- Zugriffe: 13781
- 21.01.2011, 15:04
- Forum: Regie-Reihe
- Thema: Braun Receiver 550
- Antworten: 4
- Zugriffe: 5386
- 21.01.2011, 00:57
- Forum: Regie-Reihe
- Thema: Rätselhafter Fehler Regie 510
- Antworten: 14
- Zugriffe: 13781
Klingt fuer mich beinahe wie ein Temperaturfehler. Betreibe das Geraet doch einmal in der normalen Aufstellung, warte bis der Fehler auftaucht und versuche mal Kaeltespray an den Kontakten und anderen Baugruppen. Vielleicht ist auch der Ruhestrom im linken Kanal zu hoch eingestellt und fuehrt zu die...
- 20.01.2011, 22:40
- Forum: Kompaktanlagen
- Thema: Dem TC-20 wieder zu altem glanz verhelfen...
- Antworten: 12
- Zugriffe: 13059
- 20.01.2011, 16:58
- Forum: Kompaktanlagen
- Thema: Dem TC-20 wieder zu altem glanz verhelfen...
- Antworten: 12
- Zugriffe: 13059
- 09.01.2011, 15:23
- Forum: Smalltalk
- Thema: Herr Brum alias kibosh-baiwoff?
- Antworten: 9
- Zugriffe: 8555
- 08.01.2011, 20:32
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
- 08.01.2011, 19:07
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
- 07.01.2011, 14:22
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
- 06.01.2011, 23:02
- Forum: Receiver/Verstärker
- Thema: CSV 1000/1 , NetzTrafo defekt
- Antworten: 21
- Zugriffe: 29840
- 06.01.2011, 22:54
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
- 06.01.2011, 22:43
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
Sorry, but I can't help you with the broken right channel and any repair will involve some cost. To the best of my knowledge there are no specific flaws in the CSV 510 circuitry. It doesn't make any sense that you measure less than one volt. The voltmeter must be set to AC! The light bulb is connect...
- 06.01.2011, 21:48
- Forum: Receiver/Verstärker
- Thema: Problems with CSV 510
- Antworten: 40
- Zugriffe: 68822
- 06.01.2011, 20:03
- Forum: Receiver/Verstärker
- Thema: CSV 1000/1 , NetzTrafo defekt
- Antworten: 21
- Zugriffe: 29840
Hallo Henry2, vielen Dank fuer Deine Ausfuehrungen ueber die Funktion und Grenzen des Netzteiles im CSV1000. Auf der einen Seite waere es schon der Ueberlegung wert wie man es solider auslegen koennte, auf der anderen Seite sind wohl Besitzer des fast 50 Jahre alten und seltenen Verstaerkers mehr an...
- 03.01.2011, 22:36
- Forum: Receiver/Verstärker
- Thema: Help, I need service manual for csv510
- Antworten: 2
- Zugriffe: 4659
Hi,
here is a link for many free downloads of Braun manuals including the one for the regie 510.
http://www.hifi-manuals.com/Braun
Regards
Wilhelm
here is a link for many free downloads of Braun manuals including the one for the regie 510.
http://www.hifi-manuals.com/Braun
Regards
Wilhelm
- 02.01.2011, 23:15
- Forum: Kompaktanlagen
- Thema: Audio 300 - Beleuchtung
- Antworten: 1
- Zugriffe: 3405